Helps protect your rotors from going metal to metal causing severe damage. Brake Wear Lead Sensor Kit; For FMSI Pad No. D1099; Vented; 5 Bolt Holes; 354mm Dia.; 75mm Height; 20mm Thick; 79mm Center Hole Dia.; DO NOT FIT UPGRADE PADS TO REAR OF VEHICLE UNLESS SAME UPGRADE FITTED TO FRONT, The Thermic Black coating? does NOT need to be removed before install. Do NOT use brake cleaner or any other method to remove Thermic Black coating from discs rotors. The Thermic black coating will be removed in the pad swept area by the brake pads with in the first 10 to 20 stops made after installation on the vehicle.The Thermic Black coating? is an anti corrosion coating for long resistance against rust. Attempting to remove Thermic Black Coating with brake cleaner or any other method is NOT covered under EBC warranty Rear Wear Leads 2007 thru 2009 LAND ROVER Range Rover Sport 4.2 Supercharged